Click on “Download PDF” for the PDF version or on the title for the HTML version.
If you are not an ASABE member or if your employer has not arranged for access to the full-text, Click here for options.
SOLID SEPARATION EQUIPMENT VERIFICATION TESTING PROTOCOL
Published by the American Society of Agricultural and Biological Engineers, St. Joseph, Michigan www.asabe.org
Citation: Pp. 472-486 in the Ninth International Animal, Agricultural and Food Processing Wastes Proceedings of the 12-15 October 2003 Symposium (Research Triangle Park, North Carolina USA), Publication Date 12 October 2003. 701P1203.(doi:10.13031/2013.15285)
Authors: J.J. Classen, F.J. Humenik, J.M. Rice
Keywords: Swine, solid separation, nutrient partitioning
This paper describes a protocol for the evaluation of solids separation technology for the U.S.
Environmental Protection Agencys Environmental Technology Verification (ETV) Program.
Verification activities for solids separation technologies shall be conducted under the ETV Water
Quality Protection Center, which is overseen by the U.S. Environmental Protection Agency
(USEPA) and NSF International (NSF), with technical assistance and oversight from North
Carolina State University (NCSU).
(Download PDF) (Export to EndNotes)
EPA instituted the ETV Program to verify the performance characteristics of commercial-ready
environmental technologies through the evaluation of objective and quality-assured data. The
general test plan described here is designed to determine the effectiveness of a solid separation
device in separating solids from liquid swine waste from the NCSU farm with between
approximately 0.5% and 1.0% total solids over a period of four weeks. The verification process is
therefore limited in scope to waste from a specific farm and of limited solids content. While the
four week verification period allows observation of some operational problems, it is expected that
not all maintenance problems will manifest themselves. Within these limits, the verification
process provides a means to evaluate various solid separation systems under similar conditions.
Although the primary purpose of solid separators is to remove and recover solid material, the
implementation of these systems will have an impact on the entire waste management system. It
is therefore necessary to quantify the effect this equipment has on the partitioning of other waste
constituents of interest such as nitrogen, phosphorus, potassium, copper, and zinc. Technical
professionals will need this information to determine the value of the separated material as well as
to design subsequent waste treatment and land application operations.
The overriding principle of this test is an accounting of the mass of each waste stream and its
constituents. The critical requirement is measurement of both volume and concentration for each
component of interest. Therefore, tests will be run using a fixed volume of wastewater from a mixing tank. In this way, the partitioning of the constituents between the liquid and solid phases
can be determined. Twelve samples will be collected over a four-week period.